Expert Jeep DPF cleaning
The diesel particulate filter on your Jeep — fitted with the CRD (VM Motori) diesel engine — captures soot from the exhaust and burns it off during regeneration. Jeep CRD diesels commonly block their DPF when used mostly around town. When the filter blocks, you'll often see a warning light, lose power, use more fuel, or drop into limp mode.
Rather than replacing an expensive factory part, our off-car cleaning process removes the trapped soot and ash and restores your Jeep DPF to near-original flow — for a fraction of the cost.
Common signs on your Jeep
Jeep Grand Cherokee CRD diesels use the same VM Motori-derived engine family as some Chrysler models, and owners who use the vehicle mainly for suburban driving rather than open-road touring see filters block up well before they should.
A blocked filter on this engine family can trigger fault codes such as P244A, P242F — both indicate the DPF needs attention rather than a new part.
Jeep models we service
We clean DPFs across the Jeep diesel range, including popular models such as Grand Cherokee, Cherokee CRD, as well as other Jeep diesels. Not sure if yours qualifies? Just call us.
Why clean instead of replace?
- ✓ Save thousands — a new Jeep DPF costs $3,000–$7,000 fitted
- ✓ Same-day turnaround — usually 3 to 4 hours
- ✓ Flow-tested before and after, so you see the result
- ✓ Australia-wide by post if you're outside Sydney
Our process
- Diagnose and remove the Jeep DPF
- Initial flow test to measure the blockage
- Deep clean to remove soot and ash
- Second flow test to confirm the result
- Refit, clear fault codes and road test